Power UNITS FOR LIFT TABLE 1
General Description
This electrical power unit is created solely for that tiny lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit is widely employed within the sector of logistic units such as minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed through the solenoid valve together with the speed managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Common Description
This power unit is intended solely for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the velocity managed through the adjustable needle valve. Once the lift rises to a high positoin, but the energy supply is reduce, the lowering motion is managed through the guide override function.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This energy unit is made solely to the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the speed managed by a strain compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
General Description
This energy unit is designed solely to the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as speed controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is cut, the reducing motion is controlled by the guide override perform.
Unique Notes
1. This power unit is of S3 duty cycle, which could only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic elements concerned ahead of set up of the power unit.
three. Viscosity on the oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is needed following the initial a hundred operation hrs,afterwards once just about every 3000 hrs.
five. The power unit proven is built to be mounted vertically.