Materials Handling Power UNIT 1
Common Description
This power unit is developed for that fork lift marketplace, consisting of very effective gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down movement are managed by the lever on the manual release valve, that is equipped with an electrical switch to activate the motor. The lowing speed is managed by the stress 
compensated movement handle valve.
Exclusive Notes
1. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic components concerned before set up of the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should really also be clean and no cost of impurities, N46 hydraulic oil is encouraged .
4. Oil altering is required following the preliminary 100 operation hours, afterwards as soon as every single 3000 hours.
5. The energy unit shown is made to be mounted horizontally.
Material Handling Electrical power UNIT two
Standard Description
This electrical power unit features electrical power up gravity down circuit. Activate the start off solenoid to start out the motor to lift the machine. The lowing movement is activated from the solenoid valve with all the decreasing velocity managed through the pressure compensated movement manage valve. Products of this series is often broadly used in the marketplace of logistic products such as fork lift, mini lift table, and so on.
Exclusive Notes
1. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean each of the hydraulic components concerned in advance of mounting the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which really should also be clean and totally free of impurities, N46 hydraulic oil is encouraged .
four. Oil transforming is required after the first 100 operation hours,afterwards as soon as each 3000 hours.
five. The power unit must be mounted horizontally.